How easy it it to change a processor inside a pc? and the RAM?

What tools are needed?How easy it it to change a processor inside a pc? and the RAM?It's very easy, but you have to be very careful and make sure you are grounded so there is no static electricity. You just need a phillipshead screwdriver to get the side of the case off. The RAM just pops in the slot and the CPU is under a heatsink and fan assembly that you have to remove first.How easy it it to change a processor inside a pc? and the RAM?Incredibly easy. A screwdriver to remove the lid from the unit (some systems you don't even need a screwdriver). RAM can be changed by hand (little clips hold the RAM pcb in place. You can also change the processor by hand, may need a small flathead screw driver to remove the Processor after you have taken off the fan and heatsink (metal thing). Make sure you're somewhere to reduce the amount of static. Like not on a carpet etc in case it damages the boards as you hold them. An anti-static wrist-band is quite cheap however if you want to be doubly sure.How easy it it to change a processor inside a pc? and the RAM?RAM is easy - providing you have the same type. They just push into slots on the motherboard and are held by clips at the ends. Make sure static is discharged, preferably by wearing a wrist strap connected to the PC frame. Processor is going to be more difficult - again it must be the same slot type. The heatsink is mounted on to the processor using special heat conducting gel.How easy it it to change a processor inside a pc? and the RAM?The tools are very basic, a few screwdriver.



The ram is easy just be careful to pull it out along the correct angle. And to get a snap when you push the ram in. Again do not push too hard, just enough.



The CPU is harder, but doeable, find a good how to site with pictures. Maybe MaximumPC.com. Every mother can only accpet certain types of CPU and Ram so make sure you get the correct type.How easy it it to change a processor inside a pc? and the RAM?Before you do it go to www.kenyada.com and see how it is done in a step by step procedure.Click on to building a computer.